Canon MX850 Network Setup Guide - Page 19

1 Preparing for Setup Before installing the MP Drivers in your computer, make sure of the following. z If the installation and adjustment of the machine have not been finished, refer to your setup sheet to set up the machine properly. z Turn off the firewall function temporarily or change its setting. If you disable the firewall function, disconnect your network from the Internet. For information on the firewall function of your security software, refer to its instruction manual or contact its manufacturer. Important After setup is complete, turn back on the firewall function you disabled for setup. If you connect to a network that is not protected with security measures, there is a risk of disclosing data such as your personal information to a third party. z Make sure that the configuration of computers, hubs, and other network devices is complete, and computers can connect to the network. The configuration and the type of the device vary depending on your network environment. For details, refer to your device's instruction manual or contact its manufacturer. Important A hub and LAN cable are required to connect this machine to a wired LAN. These must be purchased separately. Note z In an office setup, consult your network administrator. z Since Mac® OS 9, Mac OS X Classic environments, or Mac OS X v.10.3.8 or earlier are not supported, do not connect the machine to these. z Log on as an Administrator. z Quit all running applications before installation. The screens in this manual refer to Mac OS X v.10.4.x installation. Screens may vary depending on the operation system you are using and also depending on the country or region of purchase. Setting Up the Machine and the Computer (Macintosh) 17