Cisco 7961G Administration Guide - Page 108

Overview of Options Configurable from a Phone Chapter 4 Configuring Settings on the Cisco Unified IP Phone Note There are several options on the Network Configuration menu and on the Device Configuration Menu that are for display only or that you can configure from Cisco Unified CallManager. These options are also described in the "Network Configuration Menu" section on page 4-7 or the "Device Configuration Menu" section on page 4-15. Table 4-1 Settings Configurable from a Cisco Unified IP Phone Category Description Network Configuration Menu Option DHCP settings Dynamic Host Configuration Protocol (DHCP) automatically assigns IP address to devices when you connect them to the network. Cisco Unified IP Phones enable DHCP by default. DHCP Enabled DHCP Address Released IP settings If you do not use DHCP in your network, you can Domain Name make IP settings manually. IP Address Subnet Mask Default Router 1-5 DNS Server 1-5 TFTP settings If you do not use DHCP to direct the phone to a TFTP server, you must manually assign a TFTP server. You can also assign an alternative TFTP server to use instead of the one assigned by DHCP. TFTP Server 1 Alternate TFTP TFTP Server 2 VLAN settings Admin. VLAN ID allows you to change the administrative VLAN used by the phone. PC VLAN allows the phone to interoperate with third-party switches that do not support a voice VLAN. Admin. VLAN ID PC VLAN Port settings Allow you to set the speed and duplex of the network and access ports. SW Port Configuration PC Port Configuration Related Topics • Displaying a Configuration Menu, page 4-2 Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE Administration Guide for Cisco Unified CallManager 4-6 OL-11528-01