Cisco WRT300N User Manual - Page 18

Wireless-N Broadband Router Static IP If you are required to use a permanent IP address, then select Static IP. Internet IP Address. This is the IP address that the Router has, when seen from the Internet. Your ISP will provide you with the IP address you need to specify here. Subnet Mask. This is the Router's Subnet Mask, as seen by external users on the Internet (including your ISP). Your ISP will provide you with the Subnet Mask. Default Gateway. Your ISP will provide you with the Default Gateway Address. DNS 1-3. Your ISP will provide you with at least one DNS (Domain Name System) Server IP Address. PPPoE Some DSL-based ISPs use PPPoE (Point-to-Point Protocol over Ethernet) to establish Internet connections for end-users. If you use a DSL line, check with your ISP to see if they use PPPoE. If they do, you will have to enable it. User Name and Password. Enter the User Name and Password provided by your ISP. Service Name. If provided by your ISP, enter the Service Name. Connect on Demand and Max Idle Time. You can configure the Router to cut the Internet connection after it has been inactive for a specific period of time (Max Idle Time). If your Internet connection has been terminated due to inactivity, Connect on Demand enables the Router to automatically re-establish your connection as soon as you attempt to access the Internet again. To use Connect on Demand, click the radio button. If you want your Internet connection to remain on at all times, enter 0 in the Max Idle Time field. Otherwise, enter the number of minutes you want to have elapsed before your Internet access disconnects. Keep Alive and Redial Period. This option keeps your Internet access connected indefinitely, even when it sits idle. If you select this option, the Router will periodically check your Internet connection. If the connection is down, then the Router will automatically re-establish the connection. To use this option, click the radio button next to Keep Alive. The default Redial Period is 30 seconds. Click the Save Settings button. Then click the Status tab, and click the Connect button. IMPORTANT: For DSL users, if you need to enable PPPoE support, remember to remove any PPPoE applications that are installed on your PCs. Figure 5-3: Static IP static ip address: a fixed address assigned to a computer or device connected to a network. subnet mask: an address code that determines the size of the network default gateway: a device that forwards Internet traffic from your local area network Figure 5-4: PPPoE pppoe: a type of broadband connection that provides authentication (username and password) in addition to data transport Chapter 5: Configuring the Wireless-N Broadband Router 12 The Setup Tab - Basic Setup