Compaq Evo n800c Maintenance and Service Guide - Page 167
Remove the PC Card bezel, Removing the System Board
View all Compaq Evo n800c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 167 highlights
Removal and Replacement Procedures 7. Use the MultiBay connector 1 to lift 2 the front of the system board until the board rests at an angle (Figure 5-35). 8. Slide the system board forward at an angle 3 and remove it from the base enclosure. 9. Remove the PC Card bezel 4 from the system board. Figure 5-35. Removing the System Board Reverse the above procedure to install the system board. 5-48 Maintenance and Service Guide
5–48
Maintenance and Service Guide
Removal and Replacement Procedures
7. Use the MultiBay connector
1
to lift
2
the front of the
system board until the board rests at an angle (Figure 5-35).
8. Slide the system board forward at an angle
3
and remove it
from the base enclosure.
9. Remove the PC Card bezel
4
from the system board.
Figure 5-35. Removing the System Board
Reverse the above procedure to install the system board.