D-Link DWS-3024 Product Manual - Page 114

D-Link Unified Access System User Manual Table 18 describes the Channel Plan History fields Table 18. Channel Plan History Field 802.11a 802.11g Operational Status Last Iteration Last Algorithm Time AP MAC Address Location Radio Iteration Channel Description The 802.11a and 802.11g radios use different channel plans, so the switch tracks the channel history separately for each radio. The channel information that displays on the page is only for the radio you select. This field shows whether the switch is using the automatic channel adjustment algorithm on the D-Link Access Point radios. The number in this field indicates the last iteration of channel plan adjustments. The APs that received a channel adjustment in previous iterations cannot be assigned new channels in the next iteration to prevent the same APs from being changed time after time. On the AP Management > RF Management > Configuration tab, you can set the history depth to control the maximum number of iterations stored and displayed in the channel plan history. Shows the date and time when the channel plan algorithm last ran. NOTE: To set the system time on the switch, you must use SNTP, which is disabled by default. From the Web interface, you configure the SNTP client and server information from the LAN > Administration > SNTP Settings page. From the CLI, use the sntp commands in Global Config mode. This table displays the channel assigned to an AP in an iteration of the channel plan. Initiating Manual Channel Plan Assignments If you specify Manual as the Channel Plan Mode on the Configuration tab, the Manual Channel Plan page allows you to initiate the Channel Plan algorithm. To manually run the channel plan adjustment feature, select the radio to update the channels on (802.11a or 802.11g) and click the Start button. Figure 52. Manual Channel Plan 114 © 2001- 2008 D-Link Corporation. All Rights Reserved.