D-Link DWS-3024 Product Manual - Page 222
Associate the L3 Tunnel Network network 3 with VAP 2.
UPC - 790069288760
View all D-Link DWS-3024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 222 highlights
D-Link Unified Access System User Manual VAP 0 is the default network and is the only network enabled by default. In this example, the Guest networks is on VAP 0, the Corporate Network is on VAP 1, and the L3 Tunnel Network is on VAP 2. (switch-prompt) (Config-ap-radio)#vap 2 (switch-prompt) (Config-ap-profile-vap)#enable 9. Associate the L3 Tunnel Network (network 3) with VAP 2. (switch-prompt) (Config-ap-profile-vap)#network 3 10. Enter CTRL + Z to exit to Privileged EXEC mode and view the network configuration to make sure the L3 Tunnel Status is listed as "Configured" and to confirm that other network settings are correct. (switch-prompt) #show wireless network 3 Network ID 3 SSID L3 Tunnel Default VLAN 1 Hide SSID Disable Deny Broadcast Disable L3 Tunnel Mode Enable L3 Tunnel Status Configured L3 Tunnel Subnet IP 192.168.60.0 L3 Tunnel Subnet Mask 255.255.255.0 Security Mode WPA Enterprise MAC Authentication Disable RADIUS Use AP Profile Enable RADIUS Server IP 0.0.0.0 RADIUS Secret Configured No RADIUS Accounting Disable WPA Versions WPA/WPA2 WPA Ciphers TKIP WPA Key Type ASCII WPA Key WPA2 Pre-Authentication Enable WPA2 Pre-Authentication Limit (minutes)........ 0 WPA2 Pre-Authentication Timeout (minutes)...... 0 --More-- or (q)uit WPA2 Key Forwarding Enable WPA2 Key Caching Holdtime (minutes 10 WEP Authentication Type Open System WEP Key Type HEX WEP Key Length (bits 128 WEP Transfer Key Index 1 WEP Key 1 WEP Key 2 WEP Key 3 WEP Key 4 An important value to note is the L3 Tunnel Status value. The following table lists the 222 © 2001- 2008 D-Link Corporation. All Rights Reserved.