D-Link DWS-3024 Product Manual - Page 219
L2 Features > VLAN > Configuration
UPC - 790069288760
View all D-Link DWS-3024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 219 highlights
L3 Roaming Example 3. Exit to Privileged EXEC mode and view the VLAN routing interface configuration. (switch-prompt) (Vlan)#exit (switch-prompt) #show ip vlan MAC Address used by Routing VLANs: 00:00:00:01:00:02 VLAN ID ------200 Logical Interface 0/4/1 IP Address 0.0.0.0 Subnet Mask 0.0.0.0 The new VLAN routing interface is 0/4/1 in unit/slot/port format. For non-stacking platforms, the interface would be 4/1. 4. Enter the interface configuration mode for the new VLAN routing interface. (switch-prompt) #configure (switch-prompt) (Config)#interface 0/4/1 5. Assign an IP address to the interface and enable routing. (switch-prompt) (Interface 0/4/1)#ip address 192.168.60.15 255.255.255.0 (switch-prompt) (Interface 0/4/1)#routing 6. Add the port to which the call server is attached to VLAN 200 (in this example, the call server is attached to port 3). (switch-prompt) (Config)#interface 1/0/3 (switch-prompt) (Interface 1/0/3)#vlan participation include 200 To perform the same steps by using the Web interface, use the following procedures: 1. From the L2 Features > VLAN > Configuration page, create a VLAN, give it a name, and add the port to which the call server is attached to VLAN 200 (in this example, the call server is attached to port 3). Configuring the WLAN and Tunnel Interfaces 219