Dell Inspiron 27 7710 All-in-One Service Manual - Page 58
Installing the antennas
View all Dell Inspiron 27 7710 All-in-One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Installing the antennas Prerequisites If you are replacing a component, remove the existing component before performing the installation process. About this task The following image indicates the location of the antennas and provides a visual representation of the installation procedure. NOTE: Note the location of the antenna modules that are printed on the display-assembly base as ANT-B (black) and ANT-W (white). Steps 1. Align and place the antenna modules (2) into the slots on the display-assembly base and adhere it in place. 2. Adhere the copper foil that secures the antenna cables (2) to the display-assembly base. 3. Route the antenna cables through the routing guides on the display-assembly base. Next steps 1. Install the power-button board. 2. Install the display hinges. 3. Install the media-card reader. 4. Install the system board. 5. Install the speakers. 6. Install the heat sink. 7. Install the wireless card. 8. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive. 9. Install the memory module. 10. Install the system-board shield. 11. Install the hard drive. 12. Install the I/O cover. 13. Install the back cover. 14. Install the stand. 15. Follow the procedure in After working inside your computer. 58 Removing and installing components