Denon AVR 1906 Owners Manual - Page 50

ENGLISH Advanced Setup - Part 2 4 When "Auto" mode is selected: Press the CURSOR F or G button to adjust all -1 the speakers to the same volume. • The test tones are emitted from each speaker in the following order: at 4-second intervals during the first and second cycle, and at the 2-second intervals during the third and subsequent cycles. FL C FR SR 2sp SW SL SBL SBR SB 1sp When the surround back speaker setting is set to "1sp" for "Speaker Configuration", this is set to "SB". Example: When the volume is set to -12 dB while the test tone is being produced from the Front Lch speaker The volume can be adjusted between -12 dB and +12 dB in units of 1 dB. 4 When "Manual" mode is selected: Press the CURSOR D or H button to select the -2 speaker, then press the CURSOR F or G button to adjust all the speakers to the same volume. • To cancel the settings, press the CURSOR H button to select "Level Clear" on the "Channel Level" screen, then make the settings again. • When adjusting the level of an active subwoofer system, you may also need to adjust the subwoofer's own volume control. • When you adjust the channel levels while in the system setup channel level mode, the channel level adjustments made will affect all surround modes. Consider this mode a master channel level adjustment mode. • After you have completed the system setup channel level adjustments, you can then activate the individual surround modes and adjust channel levels that will be remembered for each of those modes. Then, whenever you activate a particular surround sound mode, your preferred channel level adjustments for just that mode will be recalled. Check the instructions for adjusting channel levels within each surround mode ( page 28). 2 Adjusting the test tone • Before playing with the surround function, be sure to use the test tones to adjust the playback level from the different speakers. This adjustment can be performed with the system setup ( page 46, 47) or from the remote control unit, as described below. • Adjusting with the remote control unit using the test tones is only possible in the "Auto" mode and only effective in the STANDARD (DOLBY/DTS SURROUND) modes. The adjusted levels for the different modes are automatically stored in the memory. Advanced Setup - Part 2 Setting the Crossover Frequency Set the crossover frequency mode according to the speaker system being used. 1 Press the CURSOR D or H button to select "Crossover Frequency" at the "Speaker Setup" menu, then press the ENTER button. • The "Crossover Frequency" screen appears. 2 Press the CURSOR F or G button to select the frequency. 40 / 60 / 80 / 100 / 120 / 150 / 200 / 250 Hz can be selected. 3 Press the ENTER button to enter the setting. • The "Speaker Setup" menu appears. 1 Press the STANDARD button to select the STANDARD (DOLBY/DTS SURROUND) modes. 5 Press the ENTER button to enter the setting. • The "Speaker Setup" menu appears. 2 Press the TEST TONE button. • Test tones are output from the different speakers. 3 Press the CURSOR F or G button to adjust so that the volume of the test tones is the same for all the speakers. 4 After completing the adjustment, press the TEST TONE button again. 47 ENGLISH