Denon AVR-3805 Owners Manual - Page 25
About automatic retry, About the error message - reset
UPC - 081757505987
View all Denon AVR-3805 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
5 Start the measurements. Measurement of each channel is performed as follows. Display 1 2 FL FR C SW SLA SRA SLB SRB SBL SBR 1 Subwoofer speaker is measured twice. 2 When "ZONE2" or "ZONE3" is selected, this is not displayed. After each channel is measured, "Calculating" appears. The display switches to Auto Setup check screen automatically. NOTES: • Measurement is canceled when MASTER VOLUME is operated while the Auto Setup is performed. • Set the volume to halfway and set the crossover frequency to the maximum or Low pass filter off if your subwoofer speaker can adjust the output volume and the crossover frequency. About automatic retry Remeasurement starts automatically to receive proper result of measurement. Remeasurement is performed to 2 times, and "Retry1" or "Retry2" is displayed on screen during remeasurement. About the error message These error screens will be displayed when performing the measurements of Auto Setup/Room EQ and the automatic measurements can not be completed because of the speaker arrangement, measurement environment, or other factors. Please check the following matters, reset the pertinent items, and measure again. When there is too much noise in the room, the speakers may not be detected properly. Should this happen, perform the measurements when the noise level is low, or switch off the power of the equipment that is producing the noise for the duration of the measurements. q This screen will be displayed when the speakers required for producing suitable reproduction have not been detected. • The front L and front R speakers were not properly detected. • Only one channel of the surround (A) and surround (B) speakers was detected. • Sound was output from the R channel when only one surround back speaker was connected. • The surround back or the surround (B) speaker was detected, but the surround (A) speaker was not detected. Check that the pertinent speakers are properly connected. (see page 15) e This screen will be displayed when accurate measurements cannot be made due to the input level to the microphone being too high. Set up the speakers so that their position is farther away from the listening position. Lower the volume of the subwoofer speaker. w This screen will be displayed when the speaker polarity is connected in reverse. Check the polarity of the pertinent speakers. r This screen will be displayed when the measurement microphone is not connected, or when all of the speakers have not been detected. Connect the measurement microphone to the microphone connector. Check the speaker connections. 25