Denon AVR-3805 Owners Manual - Page 36
Setting the crossover frequency - dts master
UPC - 081757505987
View all Denon AVR-3805 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
8 CH SEL ENTER Enter the setting. CH SEL The "Channel Level" screen reappears. ENTER (Remote control unit) (Main unit) To cancel the settings, press the CURSOR down to select "Level Clear" and "Yes" on the "Channel Level" screen, then make the settings again. The level of each channel should be adjusted to 75 dB (C-weighted, slow meter mode) on a sound level meter at the listening position. If a sound level meter is not available adjust the channels by ear so the sound levels are the same. Because adjusting the subwoofer level test tone by ear is difficult, use a well known music selection and adjust for natural balance. NOTE: When adjusting the level of an active subwoofer system, you may also need to adjust the subwoofer's own volume control. When you adjust the channel levels while in the SYSTEM SETUP CHANNEL LEVEL mode, the channel level adjustments made will affect all surround modes. Consider this mode a Master Channel Level adjustment mode. After you have completed the SYSTEM SETUP CHANNEL LEVEL adjustments, you can then activate the individual surround modes and adjust channel levels that will be remembered for each of those modes. Then, whenever you activate a particular surround sound mode, your preferred channel level adjustments for just that mode will be recalled. Check the instructions for adjusting channel levels within each surround mode. (See page 72) You can adjust the channel levels for each of the following surround modes: PURE DIRECT/DIRECT, STEREO, DOLBY/DTS SURROUND, 5/7 CH STEREO, WIDE SCREEN, SUPER STADIUM, ROCK ARENA, JAZZ CLUB, CLASSIC CONCERT, MONO MOVIE, VIDEO GAME, MATRIX and VIRTUAL. When using either surround speakers A or B, or when using surround speakers A and B at the same time, be sure to adjust the balance of playback levels between each channel for the various selections of "A or B" and "A and B". 2-4 Setting the crossover frequency • Set the crossover frequency mode according to the speaker system being used. 1 Select the "Crossover Frequency" at the Speaker Setup Menu. CH SEL ENTER CH SEL ENTER (Remote control unit) (Main unit) *Speaker Setup Crossover Freq. 2 CH SEL ENTER Display the Crossover Frequency screen. CH SEL ENTER (Remote control unit) 3 CH SEL ENTER (Main unit) CH SEL ENTER (Remote control unit) (Main unit) 4 CH SEL ENTER CH SEL ENTER Select the frequency. *Crossover Freq 80Hz • 40 / 60 / 80 / 100 / 120 / 150 / 200 / 250 Hz can be selected. Enter the setting. The Speaker Setup Menu reappears. (Remote control unit) (Main unit) 36