Denon AVR-791 Owners Manual - English - Page 12
Calculating, Check, Store, Finish - remote
UPC - 883795001359
View all Denon AVR-791 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Simple version Basic version Step 3 Calculating Step 4 Check Step 5 Store ENGLISH Set up speakers (Audyssey® Auto Setup) Finish 10 On the Step 2 screen, use ui to select "Calculate", and then press ENTER. Measuring results are analyzed, and the frequency response of each speaker in the listening room is determined. Step3:Calculating MultEQ Calculating Please wait... [----------] • Analysis takes several minutes to complete. The time required for this analysis depends on the number of speakers connected. The more connected speakers there are, the longer it takes to perform analysis. 11 Use ui to select the item you want to check, and then press ENTER. Step4:Check MultEQ Please check the results of the measured item. Speaker Config.Check Distance Check Channel Level Check Crossover Freq.Check Next [ENT]:Select • Subwoofers may measure a greater reported distance than the actual distance due to added electrical delay common in subwoofers. • If you want to check another item, press RETURN. 12 Use ui to select "Next" and then press ENTER. NOTE • If the result differs from the actual connection status, or if "Caution!" is displayed, see "Error messages" (vpage 10). Then carry out Audyssey Auto Setup again. • If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speaker connections and repeat the measurement process from the beginning. • If you change a speaker position or orientation, perform Audyssey Auto Setup again to obtain optimal equalizer correction. 13 Use ui to select "Store" and then press ENTER. Save the measuring results. Step5:Store MultEQ Please select "Store" to store measurement values. Store Cancel [ENT]:Store Step5:Store MultEQ Storing Please wait... [----------] • Saving the results requires about 10 seconds. • If you do not want to save the measurement results, use ui to select "Cancel", then select "Yes" using o p. All the measured Audyssey Auto Setup data will be erased. NOTE During saving of measuring results, be sure not to turn off the power. 14 Unplug the setup microphone from the unit's SETUP MIC jack. 15 Set Dynamic Volume™. Finish MultEQ Storing complete. Auto Setup is now finished. Turn on Dynamic Volume? Yes : No [ ]:Select [ENT]:Exit • For details of Dynamic Volume settings, see page 50. nn When turning Dynamic Volume on • Use o to select "Yes", and then press ENTER. The unit automatically enters "Evening" mode. nn When turning Dynamic Volume off • Use p to select "No", and then press ENTER. NOTE After performing Audyssey Auto Setup, do not change the speaker connections or subwoofer volume. In event of a change, perform Audyssey Auto Setup again. Advanced version Information Remote control operation buttons Move the cursor (Up/Down/Left/Right) Confirm the setting Return to previous menu 9