Epson BrightLink 1480Fi Installation Guide - Page 50

Make sure the Touch Unit connection cable is not wired into the wall with the other cables.

Get Epson BrightLink 1480Fi PDF manuals and user guides View all Epson BrightLink 1480Fi manuals
Add to My Manuals
Save this manual to your list of manuals

Page 50 highlights

3. Insert the hexagonal shaft into the slot at the top of the wall plate ( ). 4. Insert the hexagonal shaft into the slot at the bottom of the wall plate ( ). Caution ❏ Make sure the Touch Unit connection cable is not wired into the wall with the other cables. ❏ Take care not to trap the cables between the mount arm and wall plate. 5. Secure the mount arm to the wall plate by tightening the supplied M6 × 20 mm cross recessed head shoulder screws (×3) with the #3 cross-head screwdriver. Make sure you use the included plastic washers. If you don't use the plastic washers, you may damage the M8 hexagon bolt as you adjust the vertical slide position. 50

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
50
3.
Insert the hexagonal shaft into the slot at the top of the wall plate (
).
4.
Insert the hexagonal shaft into the slot at the bottom of the wall plate (
).
5.
Secure the mount arm to the wall plate by tightening the supplied M6 × 20 mm cross recessed head
shoulder screws (×3) with the #3 cross-head screwdriver.
Make sure you use the included plastic washers. If you don’t use the plastic washers,
you may damage the M8 hexagon bolt as you adjust the vertical slide position.
❏
Make sure the Touch Unit connection cable is not wired into the wall with the other cables.
❏
Take care not to trap the cables between the mount arm and wall plate.
Caution