Epson ColorWorks CW-C6500A Technical Reference Guide - External I/O CW-C6000/C - Page 24
Mode setting for clogged nozzle detected signal (output
View all Epson ColorWorks CW-C6500A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Mode setting for clogged nozzle detected signal (output) [Format] ^S(CNA,D,c [Parameter] c Description c = Mode setting D/E/0/1/2 Definition range [Function] Configure the mode setting for the clogged nozzle detected signal. Value for parameter c Description D/0 Turn the clogged nozzle detected signal (pin 24) OFF (not output). 1 Set the clogged nozzle detected signal (pin 24) as follows: Normal: High, When nozzle clogged: Low. E/2 Set the clogged nozzle detected signal (pin 24) as follows: Normal: Low, When nozzle clogged: High. [Initial value] 0 [Examples of command transmissions] Set the clogged nozzle detected signal to "Normal: High, When nozzle clogged: Low". The ^JUS command must be used to save the settings to the non-volatile memory in the printer. An example of the command transmission is shown below. It is sent via USB or Ethernet from the computer. ^XA ^S(CNA,D,1 ^JUS ^XZ 24