Gigabyte GA-990FXA-UD3 Manual - Page 47

OnChip SATA Port as ESP CMOS Setup Utility-Copyright (C) 1984-2011 Award Software OnChip SATA Port as ESP Port0 as ESP Port1 as ESP Port2 as ESP Port3 as ESP Port4 as ESP Port5 as ESP [Disabled] [Disabled] [Disabled] [Disabled] [Disabled] [Disabled] Item Help Menu Level  Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults Port0 as ESP/Port1 as ESP/Port2 as ESP/Port3 as ESP This option is configurable only when OnChip SATA Type is set to AHCI. Enabled will speed up the hot plug detection of the connected SATA device. (Default: Disabled) Port4 as ESP/Port5 as ESP This option is configurable only when OnChip SATA Type is set to AHCI and OnChip SATA Type Port4/5 is set to as SATA Type. Enabled will speed up the hot plug detection of the connected SATA device. (Default: Disabled) F_USB30 Controller (Etron EJ168 USB controller, USB 3.0/2.0 ports routed to the onboard F_USB30 header) Enables or disables the Etron EJ168 USB controller. (Default: Enabled) eSATA3 Controller (Marvell 88SE9172 chip, eSATA connectors on the back panel) Enables or disables the SATA controller integrated in the Marvell 88SE9172 chip. (Default: Enabled) eSATA3 Ctrl Mode (Marvell 88SE9172 chip, eSATA connectors on the back panel) Enables or disables RAID for the SATA controller integrated in the Marvell 88SE9172 chip or configures the SATA controller to AHCI mode. IDE Disables RAID for the SATA controller and configures the SATA controller to IDE mode. (Default) AHCI Configures the SATA controller to AHCI mode. Advanced Host Controller Interface (AHCI) is an interface specification that allows the storage driver to enable advanced Serial ATA features such as Native Command Queuing and hot plug. RAID Enables RAID for the SATA controller. - 47 - BIOS Setup