Gigabyte GA-990FXA-UD3 Manual - Page 89
B. Installing Windows XP - usb 3 0 driver
View all Gigabyte GA-990FXA-UD3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
B. Installing Windows XP Before installing Windows XP, connect a USB floppy disk drive to your computer first because you need to install the SATA RAID/AHCI driver from a floppy disk that contains the driver during the OS installation. Without the driver, the hard drive(s) may not be recognized during the Windows setup process. First, copy the driver from the motherboard driver disk to a floppy disk. Refer to the methods below. Method A: • For the AMD SB950, copy all files in the \BootDrv\SBxxx folder to your floppy disk. • For the Marvell 88SE9172, copy all files in the \BootDrv\Marvell\RAID folder to your floppy disk. For AHCI mode, depending on whether you want to install the 32- or 64-bit version, copy the files in the AHCI\Floppy32 or AHCI\Floppy64 folder. Method B: Steps: 1: Use an alternative system and insert the motherboard driver disk. 2: From your optical drive folder, double click the Menu.exe file in the BootDrv folder. A Command Prompt window will open similar to that in Figure 3. 3: nsert the blank formatted disk (if you're using a USB floppy disk drive, make sure it is designated as drive A). Select the controller driver by pressing the corresponding letter from the menu and press . For example, from the menu in Figure 3, • For the AMD SB950, select 3) ATi AHCI/RAID Driver for XP. • For the Marvell 88SE9172, select 10) Marvell RAID driver. (For AHCI drive(s), select Marvell AHCI driver.) Your system will then automatically copy the driver files to the floppy disk. Press any key to exit when finished. Figure 3 - 89 - Appendix