HealthRider 230 English Manual - Page 9
Arm Assembly
View all HealthRider 230 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Arm Assembly 13 13. Press Arm AssemblyÑLocate and open the parts bag labeled ÒARM ASSEMBLY.Ó 8 58 Press a 2Ó Square Inner Cap (28) into the open end of each press arm on the Press Frame (8). Press a 1Ó Round Inner Cap (58) into each of the indicated holes on the press arms. Locate the Press Adjustment Frame (14). 14. Tap two 1Ó Retainer Rings (32) and a 1Ó Round Cover Cap (81) onto one end of the Press Frame Tube (34). Lubricate the Press Frame Tube in its entire length. Note: Use the Cover Cap to tap on the Retainer Rings. Make sure the teeth on the Retainer Rings bend towards the Cover Cap (see inset drawing). Have one person lift up the Press Frame (8) while a second person slides the indicated end of the Press Frame Tube (34) through the bracket on the Top Frame (9) and the pre-assembled Large Bushings (44) in the Press Frame. Hold up the Press Adjustment Frame (14) and slide the Press Frame Tube through it and the bracket on the Top Frame. Secure the Press Frame Tube with two 1Ó Retainer Rings (32) and a 1Ó Round Cover Cap (81). 15. Butterfly Arm Assembly. Identify the Left Adjustment Disc (26) and Right Adjustment Disc (27) by looking at the three adjustment holes and orienting the Discs as shown in the drawing. Make sure a Butterfly Bushing (88) has been pre-assembled on each side of the Adjustment Discs. Lubricate the indicated rod on the crossbar attached to the Main Upright (1). Slide the Right Adjustment Disc (27) onto the rod. Secure the Adjustment Disc with a 3/4Ó Retainer Ring (31) and a 3/4Ó Dome Cap (82). Assemble the Left Adjustment Disc (26) in the same manner. Make sure the teeth on the Retainer Ring bend towards the Dome Cap as shown above. 16. Press two 2Ó Square Inner Caps (28) into the open ends of each Butterfly Arm (10). Wet the end of each Arm with soapy water. Slide a Butterfly Foam Pad (29) onto the indicated end of each Arm. Make sure a Butterfly Bushing (88) has been pre-assembled on each side of the Butterfly Arms. Lubricate the indicated rod on the crossbar attached to the Main Upright (1). Orient one Butterfly Arm (10) as shown and slide it onto the rod. Secure the Butterfly Arm with a 3/4Ó Retainer Ring (31) and a 3/4Ó Dome Cap (82). Make sure the teeth on the Retainer Ring bend towards the Dome Cap as shown above. Assemble the other Butterfly Arm (10) on the opposite side of the crossbar. Follow the procedure described above, but orient the Butterfly Arm as shown. 9 14 14 9 32 81 15 31 82 27 Adjustment Holes 16 1 Lubricate 10 28 28 58 28 32 81 Lubricate 44 34 8 32 Teeth 34 14 81 26 Adjustment Holes Crossbar 88 Lubricate 28 88 10 31 82 29 28