HP 166207-B21 Smart Array 5300 Controller User Guide - Page 158

Index I installing adapter board 9-8 array accelerator 9-1 batteries 9-4 cache 9-1 controller hardware 3-1 controller, flowcharts for 2-1 CPQONLIN 7-26 device drivers 8-1 multiple array controllers H-1 interim data recovery description of 1-9 limitation of D-11 internal cabling 3-4 internal connectors on board 1-2 J jumpers, setting 3-4, H-2 L LEDs blinking 7-8, E-3 identifying drives by, in ACU 7-8 interpreting drive status by E-2 lit on idle system H-4 limitations on ACU use 7-2 controller port use 3-6 CPQONLIN use 7-2 drive movement E-9 hard drive capacity 7-1 hard drive types supported E-1 number of controllers per system H-1 number of hard drives per system H-1 number of logical drives allowed per array 7-2 ORCA use 7-2 spare drive capacity 7-18 stripe size 7-13 linear memory 5-6 load balancing, defined D-7 location of other guides xi logical drive capacity extension description of E-11 procedure for 7-23 logical drives compared to array D-3 creation of, with ACU 7-19 creation of, with CPQONLIN 7-32 creation of, with ORCA 7-3 defined D-2 enlarging (extending) E-11 failure of E-2, E-4 identifying, using ACU 7-8 maximum number of, per array 7-4, 7-14 maximum size of 7-14 multiple, creating 7-14 partitioning of 7-25 recovery of, options for E-4 LVD (Low Voltage Differential) compatibility of, with SE H-2 distinction of, from Ultra3 SCSI H-2 support for 1-8 M manual configuration of array with ACU 7-16 with CPQONLIN 7-28 manuals xi maximum boot size, enabling 7-14 data preservation time 1-6 logical drive size 7-14 stripe size 7-13 maximum number of controllers per system H-1 hard drives for RAID 5 D-10 hard drives for RAID ADG D-10 hard drives per system H-1 logical drives per array 7-4, 7-14 Index-6 Compaq Smart Array 5300 Controller User Guide