HP 166207-B21 Smart Array 5300 Controller User Guide - Page 161

recovering data, general information for E-4 Recovery ROM 1-10 regulatory compliance notices A-1 replacing adapter board 9-8 array accelerator 9-1 batteries 9-4 cache 9-1 existing controller 3-2 hard drive E-7, E-8 Smart controller, restriction on 3-4 reprogramming options ROM 5-1 system ROM 4-1 resources ACU 7-1 ACU-XE 7-1 Array Diagnostic Utility E-4 automatic data recovery E-5 Compaq Insight Management Agents 8-2 Compaq Insight Manager 1-10 CPQONLIN 7-1, 7-26 Options ROMPaq 5-1 ORCA 6-3, 7-1 POST G-1 RBSU 6-1 related documents, location of xi System Configuration Utility 5-6 System ROMPaq 4-1 restrictions on ACU use 7-2 controller port use 3-6 CPQONLIN use 7-2 hard drive types supported E-1 moving drives E-9 number of controllers per system H-1 number of hard drives per port C-1 number of hard drives per system H-1 ORCA use 7-2 replacing a Smart controller 3-4 spare drive capacity 7-18 Index ROM options, updating 5-1 Recovery 1-10 system, updating 4-1 ROM-Based Setup Utility (RBSU) 6-1 ROMPaq Options ROMPaq 5-1 System ROMPaq 4-1 S S.M.A.R.T. support 1-4, 1-9 SAN Access Module support for 1-4 SCSI cable connectors, illustrated 3-5 Low Voltage Differential (LVD) 1-8 ports, on board, illustrated 1-2 standards supported 1-8 SCSI bus termination of C-1, E-1 transfer rate of C-1 SCSI CD-ROM drives, support for H-1 SCSI devices compatibility of 1-8 SCSI IDs, setting 3-3, H-2 SCSI ports location of, illustrated 1-2 restrictions on use of 1-2, 3-6 SCSI tape drives, support for 1-4, H-1 SCSI termination requirement 3-4 SCU (System Configuration Utility) 5-6 SE (Single Ended) compatibility of, with LVD H-2 sector repair, dynamic 1-9 series number for regulatory compliance A-1 size of cache 1-6 SmartStart CD sources of 4-1 updating option firmware using 5-3 updating system firmware using 4-1 Compaq Smart Array 5300 Controller User Guide Index-9