HP 166207-B21 Smart Array 5300 Controller User Guide - Page 26
Installing the Smart Array Controller
UPC - 720591292225
View all HP 166207-B21 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Installing the Hardware 4. Unplug the AC power cord from the outlet, and then from the server. IMPORTANT: If you will be replacing a Smart controller with a Smart Array controller, see the "External Cabling for Compaq Servers" section to determine the external cabling requirements. 5. Disconnect any peripheral devices from the server. WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system components and hot-plug hard drives to cool before touching them. CAUTION: Electrostatic discharge (ESD) can damage electronic components. Be sure that you are properly grounded before continuing the installation procedure. See Appendix B for ESD information. Installing the Smart Array Controller 1. Remove or open the access panel. 2. Select an available 66-MHz PCI slot. Slots that use a 64-bit interface may provide higher performance. 3. Remove the slot cover or open the hot-plug latch. Save the retaining screw, if one is present. 4. Slide the controller board along the slot alignment guide. 3-2 Compaq Smart Array 5300 Controller User Guide