HP 2500 HP Jetdirect Print Servers - Administrator Guide - Page 117

Table 4.3 Item 802.11B Configuration Parameters (5 of 7) Description Authentication Behavior: Reauthenticate on Apply Enable (check) or disable (clear) this checkbox to control authentication when you click Apply on this page, assuming valid configuration entries have been made. Note: This parameter does not apply to security or wireless configuration wizards. Changes to wireless parameters through a wizard will always cause the print server to reauthenticate. If disabled (default), the print server will not attempt reauthentication unless configuration changes cause the print server to disconnect and reconnect to the network. If enabled, the print server will always try to reauthenticate using the configuration values set. EAP/PSK Select Extensible Authentication Protocol Pre-Shared Key (EAP/PSK) for advanced authentication. EAP/PSK is typically for small networks where authentication servers are not used. If EAP/PSK authentication is selected, you will need to enter a network pass-phrase that is used to generate the pre-shared key for your network. Pass-phrase Enter a network pass-phrase that will be used to generate the pre-shared key for EAP/PSK authentication on your network. A pass-phrase must be from 8 to 63 ASCII characters in the hexadecimal range 21 through 7E (characters 0-9, a-z, A-Z and numerous special characters including Disabled (No encryption) Select Disabled (No encryption) if your wireless network does not use encryption keys for network access or communications. Enabled Select Enabled to use your encryption settings specified below for network access and communications. ENWW Using the Embedded Web Server 117