HP 2500 HP Jetdirect Print Servers - Administrator Guide - Page 129

Table 4.8 Item Miscellaneous Settings (2 of 5) Description Link settings (For wired 10/100TX networks only) Set the network link speed(10 or 100 Mbps) and communication mode (full- or half-duplex) for HP Jetdirect 10/100TX print servers. The available settings are listed below. CAUTION: If you change the link setting, network communications with the print server and network device may be lost. G AUTO: (Default) The print server uses autonegotiation to match the network's link speed and communication mode. If autonegotiation fails, 100TXHALF is set. G 10TXFULL: 10 Mbps, full-duplex operation G 10TXHALF: 10 Mbps, half-duplex operation G 100TXFULL: 100 Mbps, full-duplex operation G 100TXHALF: 100 Mbps, half-duplex operation DNS Server Specify the IP address of the DNS (Domain Name System) server. Email (SMTP) Server Specify the IP address of the preferred outgoing e-mail Simple Mail Transport Protocol (SMTP) server, for use with supported Scan devices. Scan Idle Timeout Specifies the number of seconds that an idle connection for scanning is allowed to remain open. The maximum is 3600, and the default is 300. If set to 0, the timeout is disabled and the connection will remain open until closed by the network system that is accessing the device. Locally Administered Address Specifies a locally administered address (LAA) that replaces the factory-assigned LAN Hardware (MAC) address. If LAA is used, a user-specified string of exactly 12 hexadecimal digits must be entered. For Token Ring print servers, the LAA address must start with hexadecimal 40 through 7F. For Ethernet print servers, the LAA address must start with hexadecimal X2, X6, XA, or XE, where X is any hexadecimal digit 0 through F. The default address is the factory assigned address. ENWW Using the Embedded Web Server 129