HP 2500 HP Jetdirect Print Servers - Administrator Guide - Page 211

Table 9.1 HP Jetdirect Configuration (2 of 2) Message Description PORT CONFIG: Identifies the link configuration of the RJ-45 port on the HP Jetdirect 10/100Base-TX print server: 10BASE-T HALF: 10 Mbps, half-duplex 10BASE-T FULL: 10 Mbps, full-duplex 100TX HALF: 100Mbps, half-duplex 100TX-FULL: 100Mbps, full-duplex UNKNOWN: The print server is in an initialization state. DISCONNECTED: A network connection has not been detected. Check network cables. AUTONEGOTIATION Identifies whether IEEE 802.3u Autonegotiation on the HP Jetdirect 10/100TX port is enabled (ON) or disabled (OFF). ON (default): The HP Jetdirect print server will attempt to automatically configure itself onto the network at the proper speed (10 or 100 Mbps) and mode (half or full duplex). Autonegotiation is enabled after a cold reset. OFF: You must manually configure the speed and mode using the EIO menu from the printer's control panel. If Autonegotiation is off, the settings must match those of the network for proper operation. MANUFACTURING ID: The manufacturing identification code for use by HP online support personnel. DATE MANUFACTURED: Identifies the date of manufacture of the HP Jetdirect print server. Total Packets Transmitted (HP Jetdirect 802.11b wireless print servers) Total number of frames (packets) transmitted without error. Total Packets Received (HP Jetdirect 802.11b wireless print servers) Total number of frames (packets) received by the HP Jetdirect print server without error. This includes broadcast, multicast packets, and packets specifically addressed to the print server. This number does not include packets specifically addressed to other nodes. ENWW HP Jetdirect Configuration Page 211