HP 2500 HP Jetdirect Print Servers - Administrator Guide - Page 220

TCP/IP Protocol Information Information in this section of the Jetdirect configuration page is described in Table 9.6. For error messages, see Table 9.12. Table 9.6 TCP/IP Configuration Information (1 of 4) Message STATUS: HOST NAME: IP ADDRESS: SUBNET MASK: Description Current TCP status. READY: Indicates the HP Jetdirect print server is awaiting data over TCP/IP. DISABLED: Indicates that TCP/IP was manually disabled. INITIALIZING: Indicates that the print server is searching for the BOOTP server, or trying to get the configuration file through TFTP. An additional status message may also be displayed. An error code and message is displayed if the print server is not ready. For more information, see Table 9.12. The host name configured on the print server. It may be truncated. NOT SPECIFIED: Indicates that no host name was specified in a BOOTP response or TFTP configuration file. NPIxxxxxx: The default name is NPIxxxxxx, where xxxxxx represents the last six digits of the LAN hardware (MAC) address. The Internet Protocol (IP) address assigned to the HP Jetdirect print server. This is a required entry for operation of the print server on a TCP/IP network. During initialization, a temporary value 0.0.0.0 is displayed. After two minutes, a default IP address 169.254/16 or 192.0.0.192 is assigned. NOT SPECIFIED: Indicates that an IP address is not assigned or the value is zero. The IP subnet mask configured on the HP Jetdirect print server. During initialization, a temporary value 0.0.0.0 is displayed. Depending on configuration parameters, the print server may automatically assign a usable default value. NOT SPECIFIED: Indicates that a subnet mask is not configured. ENWW HP Jetdirect Configuration Page 220