HP 3PAR StoreServ 7450 2-node HP 3PAR StoreServ 7450 Storage Troubleshooting G - Page 60
its new IP address as being validated.
View all HP 3PAR StoreServ 7450 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
• "Unable to set the storage system network configuration. The specified IPv4 gateway address is not reachable by using the specified storage system IPv4 address." This message displays in a dialog box. The error occurs if the storage system detects that the defined IPv4 gateway address could not be reached. Click Back and specify a valid IPv4 gateway address. If the error persists, contact HP Support. For information about contacting HP Support, see "Contacting HP Support about System Setup" (page 61). • "Unable to set the storage system network configuration. The storage system IPv4 address cannot be the same as the IPv4 gateway." This message displays in a dialog box. The error occurs if the storage system detects that the defined IPv4 gateway address is the same as the configured IPv4 address. Click Back and specify a different address for the IPv4 gateway address. • "Unable to set the storage system network configuration. The specified address is already in use by another machine." This message displays in a dialog box. The error occurs if the storage system detects that the defined IPv4 address is already in use by another machine. Click Back and specify a different IPv4 address. • "Unable to set the storage system network configuration. The storage system could not be reached at the new IP address. Make sure your network settings are configured correctly." This error message displays in a dialog box with Retry and Cancel buttons. This error displays when the SP is unable to reach the storage system at the new IP address. Click Cancel to close the wizard, and then begin the setup process again. • "Unable to set the storage system network configuration. The storage system did not recognize its new IP address as being validated." This error message displays in a dialog box with Retry and Cancel buttons. This error displays when the SP reaches the storage system at the new IP but fails to recognize that the SP was able to do this. Click Back and specify a valid IP address. if the error persists, contact HP Support. For information about contacting HP Support, see "Contacting HP Support about System Setup" (page 61). Errors strings for the time setup progress step • "Unable to set the storage system NTP server. An invalid address was specified." This error message displays in a dialog box. This error displays if the storage system detects that the NTP address is invalid. Click Cancel to close the wizard, and then begin the setup process again. • "Unable to set the storage system NTP server. The storage system's admin volume has not been created. This must be created before any networking information is created. Contact HP support for help." This error message displays in a dialog box with Retry and Cancel buttons. This error occurs if a previous command failed and the wizard did not detect the error, or if the system was rebooted for any reason during installation. Click Cancel to close the wizard, and then begin the setup process again. For information about contacting HP Support, see "Contacting HP Support about System Setup" (page 61). 60 Troubleshooting