HP 8/80 Fabric OS Message Reference v6.4.0 (53-1001767-01, June 2010) - Page 380
FW-1140, FW-1160, FW-1161
View all HP 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 380 highlights
42 FW-1140 Probable Cause Indicates that the number of small form-factor pluggable (SFP) state changes has risen above the high boundary. SFP state changes occur when the SFP is inserted or removed. Recommended No action is required. Respond to this message as is appropriate to the particular policy of the Action end-user installation. Severity INFO FW-1140 Message , [FW-1140], ,, INFO, , , is between high and low boundaries(High=, Low=). Current value is . Probable Cause Indicates that the number of small form-factor pluggable (SFP) state changes has changed from a value outside of the acceptable range to a value within the acceptable range. SFP state changes occur when the SFP is inserted or removed. Recommended No action is required. Respond to this message as is appropriate to the particular policy of the Action end-user installation. Severity INFO FW-1160 Message , [FW-1160], ,, INFO, , , , value has changed(High=, Low=). Current value is . Probable Cause Indicates that the number of link failures that the port experiences has changed. Link loss errors occur when a link experiences a loss of signal and fails. Both physical and hardware problems can cause link loss errors. Link loss errors frequently occur due to a loss of synchronization. Check for concurrent loss of synchronization errors and, if applicable, troubleshoot them. Recommended Action Check both ends of your cable connection. Verify that the cable and small form-factor pluggables (SFPs) are not faulty. Losses of synchronization commonly causes link failures. If you receive concurrent loss of synchronization errors, troubleshoot the loss of synchronization. Severity INFO FW-1161 Message , [FW-1161], ,, INFO, , , , is below low boundary(High=, Low=). Current value is . 304 Fabric OS Message Reference 53-1001767-01