HP 8/80 Fabric OS Message Reference v6.4.0 (53-1001767-01, June 2010) - Page 633

90 SEC-1331 SEC-1331 Message , [SEC-1331], ,, ERROR, , Attempt to enable secure mode failed. Reason: . Probable Cause Indicates the secModeEnable command failed on the fabric because default IP Filter policies are not active on the switch, or an active transaction exists on IP Filter policies. Recommended Action Verify the security event was planned. If the security event was planned, run the ipfilter --activate default_ipv4 or the ipfilter --activate default_ipv6 command to activate default IP Filter Policies. Use the ipfilter --save or the ipfilter --transabort commands to save or abort any active transaction on IP Filter policies. Then retry the secModeEnable command. Severity ERROR SEC-1332 Message , [SEC-1332], ,, ERROR, , Fabric wide policy is conflicting as is present in the fabric wide policy and 5.3 or 5.2 switches present in the fabric. Probable Cause Indicates the fabric-wide policy is conflicting. Recommended Remove either the FCS from the fabric-wide policy, or remove 5.3 and 5.2 switches from the fabric, Action or set the fabric-wide mode for FCS as Strict. Severity ERROR SEC-1333 Message , [SEC-1333], ,, INFO, , command failed. There are VF enabled switches in fabric. db(s) distribution is blocked. Probable Cause Indicates an attempt to distribute PWD or IPFILTER databases from the fabric to a switch that is VF-enabled. Recommended If the databases need to be distributed, disable VF on all the switches that have VF enabled. If the Action databases do not need to be distributed, no action is required. Severity ERROR SEC-3005 Message , [SEC-3005], , AUDIT, INFO, , Event: , Status: success, Info: Added member(s) to policy . Fabric OS Message Reference 557 53-1001767-01