HP 8/80 Fabric OS Message Reference v6.4.0 (53-1001767-01, June 2010) - Page 595

90 SEC-1078 Severity ERROR SEC-1078 Message , [SEC-1078], ,, ERROR, , No new data to abort. Probable Cause Indicates there are no new changes in the defined security policy database that can be aborted. Recommended Verify the security event was planned. Verify if there were really any changes to the defined policy Action database that can be aborted. Severity ERROR SEC-1079 Message , [SEC-1079], ,, ERROR, , The policy name is invalid. Probable Cause Indicates the policy name entered in the secPolicyCreate|Activate|Add|Delete command was invalid. Recommended Run the command again using a valid policy name. Action Severity ERROR SEC-1080 Message , [SEC-1080], ,, ERROR, , Operation denied. Please, use secModeEnable command. Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only occur when the primary fabric configuration server (FCS) is distributing the security database to the other switches in the fabric and local validation finds that there is an error in the security database. This is a rare occurrence. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database might not be correctly updated for that specific switch. Severity ERROR SEC-1081 Message , [SEC-1081], ,, ERROR, , Entered a name for a DCC policy ID that was not unique. Fabric OS Message Reference 519 53-1001767-01