HP AP775A Cisco Nexus 5000 Series Command Reference, Release 4.1(3)N1(1) (OL-1 - Page 176
lacp port-priority
UPC - 884962062708
View all HP AP775A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
lacp port-priority Chapter 2 Ethernet Commands Send comments to [email protected] lacp port-priority To set the priority for the physical interfaces for the Link Aggregation Control Protocol (LACP), use the lacp port-priority command. To return the port priority to the default value, use the no form of this command. lacp port-priority priority no lacp port-priority Syntax Description priority Priority for the physical interfaces. The range of valid numbers is from 1 to 65535. Command Default System priority value is 32768. Command Modes Interface configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines Each port configured to use LACP has an LACP port priority. You can configure a value between 1 and 65535. LACP uses the port priority in combination with the port number to form the port identifier. The port priority is used with the port number to form the port identifier. The port priority is used to decide which ports should be put into standby mode when there is a hardware limitation that prevents all compatible ports from aggregating. Note When setting the priority, note that a higher number means a lower priority. Examples This example shows how to set the LACP port priority for the interface to 2000: switch(config-if)# lacp port-priority 2000 Related Commands Command show lacp Description Displays LACP information. 2-26 Cisco Nexus 5000 Series Command Reference OL-16599-01