HP AP775A Cisco Nexus 5000 Series Command Reference, Release 4.1(3)N1(1) (OL-1 - Page 774
feature vpc, Examples
UPC - 884962062708
View all HP AP775A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 774 highlights
show vpc consistency-parameters Chapter 10 Vpc Commands Send comments to [email protected] • Enable/disable state the same per VLAN • STP global settings - Bridge Assurance setting - Port type setting-We recommend that you set all vPC peer link ports as network ports. - Loop Guard settings • STP interface settings: - Port type setting - Loop Guard - Root Guard • Maximum transmission unit (MTU) • Allowed VLAN bit set This command is not available if you have not enabled the vPC feature. See feature vpc for information on enabling vPCs. This command does not require a license. Examples This example shows how to display the vPC consistency parameters for the specified port channel: switch (config)# show vpc consistency-parameters global Legend: Type 1 : vPC will be suspended in case of mismatch Name Type Local Value Peer Value STP Mode 1 Rapid-PVST Rapid-PVST STP Disabled 1 None None STP MST 1 "" "" Region Name STP MST 1 0 0 Region Revision STP MST 1 Region Instance to VLAN Mapping STP Loopguard 1 Disabled Disabled STP Bridge 1 Enabled Enabled Assurance STP Port Type 1 Normal Normal Allowed VLAN - 1-100 1-100 Local suspended - 1-50 - VLANs This example shows how to display the vPC consistency parameters for the specified port channel: switch (config)# show vpc consistency-parameters interface port-channel 20 Legend: Type 1 : vPC will be suspended in case of mismatch Name STP Port Type Type Local Value Peer Value 1 Default Default 10-10 Cisco Nexus 5000 Series Command Reference OL-16599-01