HP AP775A Cisco Nexus 5000 Series Command Reference, Release 4.1(3)N1(1) (OL-1 - Page 332

match protocol Chapter 5 Quality of Service Commands Send comments to [email protected] match protocol To configure a class map to use a specific protocol as a match criterion, use the match protocol command. To remove the specified protocol as a match criteria, use the no form of this command. match [not] protocol protocol-name no match [not] protocol protocol-name Syntax Description not protocol-name (Optional) Negates the specified match result. Matches on the specified protocol name. Valid values are shown in Table 3. Defaults None Command Modes Class-map type qos configuration Command History Release 4.1(3)N1(1) Modification This command was introduced. Usage Guidelines The list of valid protocol names is shown in Table 3. Table 3 Protocol Names Argument arp bridging cdp clns clns_es clns_is dhcp isis ldp netbios Description Address Resolution Protocol (ARP) Bridging Cisco Discovery Protocol (CDP) Connectionless Network Service (CLNS) CLNS End Systems CLNS Intermediate System Dynamic Host Configuration (DHCP) Intermediate system to intermediate system (IS-IS) Label Distribution Protocol (LDP) NetBIOS Extended User Interface (NetBEUI) Note A maximum of eight different of the above protocols can be matched at one time. 5-14 Cisco Nexus 5000 Series Command Reference OL-16599-01