HP AP775A Cisco Nexus 5000 Series Command Reference, Release 4.1(3)N1(1) (OL-1 - Page 686

system default zone distribute full Chapter 8 Fibre Channel Commands Send comments to [email protected] system default zone distribute full To configure default values for distribution to a zone set, use the system default zone distribute full command. To revert to the defaults, use the no form of the command. system default zone distribute full no system default zone distribute full Syntax Description This command has no arguments or keywords. Command Default Distribution to active zone sets only. Command Modes Configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines This command distributes the default values for the default zone to all VSANs. The default values are used when you initially create a VSAN and it becomes active. If you do not want to use the default values, use the zoneset distribute full vsan command to distribute the operational values for the default zone. The system default zone distribute full command should only be used in conjunction with VSANs that have not yet been created; it has no effect on existing VSANs. Because VSAN 1 is the default VSAN and is always present, this command has no effect on it. Examples The following example distributes default values to the full zone set: switch(config)# system default zone distribute full The following example distributes default values to the active zone set only: switch(config)# no system default zone distribute full Related Commands Command zoneset distribute full vsan show system default zone Description Distributes the operational values for the default zone to all zone sets. Displays default values for the default zone. 8-138 Cisco Nexus 5000 Series Command Reference OL-16599-01