HP AP775A Cisco Nexus 5000 Series Command Reference, Release 4.1(3)N1(1) (OL-1 - Page 510
logging level
UPC - 884962062708
View all HP AP775A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 510 highlights
logging level Chapter 7 System Management Commands Send comments to [email protected] logging level Use the logging level command to enable logging messages from the defined facility that have the specified severity level or higher. To disable logging messages from the defined facility, use the no form of this command. logging level facility severity-level no logging level facility severity-level Syntax Description facility severity-level Defines the appropriate facility. The facilities are listed in the "System Message Logging Facilities" section on page 45. To apply the same severity level to all facilities, use the all facility. The number of the desired severity level at which messages should be logged. Messages at or numerically lower than the specified level are logged. Severity levels are as follows: • 0-emergency: System unusable • 1-alert: Immediate action needed • 2-critical: Critical condition-default level • 3-error: Error condition • 4-warning: Warning condition • 5-notification: Normal but significant condition • 6-informational: Informational message only • 7-debugging: Appears during debugging only Command Default None Command Modes Configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Examples This example shows how to enable logging messages from the AAA facility that have a severity level of 2 or higher: switch(config)# logging level aaa 2 7-10 Cisco Nexus 5000 Series Command Reference OL-16599-01