HP Engage Flex Pro-C G2 Maintenance and Service Guide - Page 26

To remove the heat sink from the drive, pull all four heat sink arms, and then pull the drive

Get HP Engage Flex Pro-C G2 PDF manuals and user guides View all HP Engage Flex Pro-C G2 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

3. Remove any expansion cards that block access to the drive (see Expansion cards on page 22). Remove the solid-state drive: 1. Use the following illustration to determine drive locations. (1) Primary solid-state drive (2) Secondary solid-state drive 2. Remove the Phillips screw (1) that secures the drive. 3. Rotate the drive upward (2), and then pull the drive (3) out of the socket. 4. To remove the heat sink from the drive, pull all four heat sink arms (1) down slightly, and then pull the arms out of the slots (2) in the bracket. 20 Chapter 4 Removal and replacement procedures

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
3.
Remove any expansion cards that block access to the drive (see
Expansion cards
on page
22
).
Remove the solid-state drive:
1.
Use the following illustration to determine drive locations.
(1)
Primary solid-state drive
(2)
Secondary solid-state drive
2.
Remove the Phillips screw
(1)
that secures the drive.
3.
Rotate the drive upward
(2)
, and then pull the drive
(3)
out of the socket.
4.
To remove the heat sink from the drive, pull all four heat sink arms
(1)
down slightly, and then pull the
arms out of the slots
(2)
in the bracket.
20
Chapter 4
Removal and replacement procedures