HP Engage Flex Pro-C G2 Maintenance and Service Guide - Page 52
Update the SMBIOS information in Computer Setup.
View all HP Engage Flex Pro-C G2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
2. Remove the eight Torx screws from the board. 3. Lift the front of the system board (1) up, and then lift the system board out of the computer (2). To install the system board, reverse the removal procedure. NOTE: When replacing the system board, you must change the chassis serial number in the BIOS. When replacing the system board, you must reprogram the SMBIOS information about the affected computer. Failure to reprogram the board will result in eventual failure, such as an activation failure (when you would have to reactivate the computer) or a system recovery failure. Update the SMBIOS information in Computer Setup. 46 Chapter 4 Removal and replacement procedures
2.
Remove the eight Torx screws from the board.
3.
Lift the front of the system board
(1)
up, and then lift the system board out of the computer
(2)
.
To install the system board, reverse the removal procedure.
NOTE:
When replacing the system board, you must change the chassis serial number in the BIOS.
When replacing the system board, you must reprogram the SMBIOS information about the affected
computer. Failure to reprogram the board will result in eventual failure, such as an activation failure
(when you would have to reactivate the computer) or a system recovery failure.
Update the SMBIOS information in Computer Setup.
46
Chapter 4
Removal and replacement procedures