HP Engage Flex Pro G2 Maintenance and Service Guide - Page 49
Speaker, Remove the speaker
View all HP Engage Flex Pro G2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
8. Pull the assembly and cables (4) out of the front of the computer. To install the front I/O assembly, reverse the removal procedure. Speaker To remove the speaker, use this procedure and illustration. Before removing the speaker, follow these steps: 1. Prepare the computer for disassembly (see Preparation for disassembly on page 20). 2. Remove the access panel (see Access panel on page 21). 3. Remove the optical drive (see Optical drive on page 23). 4. Rotate the drive cage to the upright position (see Rotating the drive cage on page 26). Remove the speaker: 1. Disconnect the speaker cable from the SPKR connector (1) on the system board. 2. Under the drive cage, pull the rubber speaker connectors (2) away from each other to release the speaker. 42 Chapter 4 Removal and replacement procedures