HP Engage Go 10 Maintenance and Service Guide - Page 32
Solid-state drive
View all HP Engage Go 10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
3. Remove the battery from the computer (3). To install the battery, reverse the removal procedure. Solid-state drive To remove the solid-state drive, use this procedure and illustration. For a list of available solid-states drives, see Computer major components on page 9. Before removing the solid-state drive, follow these steps: 1. Prepare the computer for disassembly (see Preparation for disassembly on page 21). 2. Remove the display assembly (see Display assembly on page 21). 3. Disconnect the battery cable from the system board (see Battery on page 23). Remove the solid-state drive: 1. Use the tab to pull the plastic cover off the top of the drive (1). 2. Remove the screw that secures the drive (2). 3. Pull the drive out of the socket (3). To install the solid-state drive, reverse the removal procedure. 24 Chapter 4 Removal and replacement procedures