HP Engage Go 10 Maintenance and Service Guide - Page 40
Pogo connector
View all HP Engage Go 10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
2. Use tweezers to lift the module out of the computer (2). The module is secured with adhesive. To install the camera LED module, reverse the removal procedure. Pogo connector To remove the pogo connector, use this procedure and illustration. Before removing the pogo connector, follow these steps: 1. Prepare the computer for disassembly (see Preparation for disassembly on page 21). 2. Remove the display assembly (see Display assembly on page 21). 3. Disconnect the battery cable from the system board (see Battery on page 23). Remove the pogo connector: 1. Disconnect the cable from the reverse ZIF connector on the system board (1). 2. Remove the two Phillips screws (2) from the connector. 3. Pull the pogo connector into the computer slightly, and then remove it from the computer (3). 32 Chapter 4 Removal and replacement procedures