HP Engage Go 10 Maintenance and Service Guide - Page 41
Power button board
View all HP Engage Go 10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
4. If you need to remove the pogo docking connectors, remove the Phillips screw (1) from each holder, and then remove the holders from the computer (2). To install the pogo connector and docking connectors, reverse the removal procedures. Power button board To remove the power button board, use this procedure and illustration. Before removing the power button board, follow these steps: 1. Prepare the computer for disassembly (see Preparation for disassembly on page 21). 2. Remove the display assembly (see Display assembly on page 21). 3. Disconnect the battery cable from the system board (see Battery on page 23). Remove the power button board: 1. Disconnect the cable from the reverse ZIF connector on the system board (1). 2. Remove the two Phillips screws (2) from the board. Power button board 33