HP F4280 User Guide - Page 110

Troubleshooting Solution 2: Check the print quality setting Solution: Check the quality setting. Use a higher quality setting to increase the amount of ink used for printing. NOTE: For maximum dpi resolution, go to the Advanced tab, and then select Enabled from the Maximum dpi drop-down list. For more information, see Print using Maximum dpi. For more information, see: • Change the print speed or quality • Print using Maximum dpi • Make a Fast copy Cause: The print quality setting was set too low. If this did not solve the issue, try the next solution. Solution 3: Rotate the image Solution: If the problem persists, use the software you installed with the product or another software application to rotate your image 180 degrees so that the light blue, gray, or brown hues in your image do not print at the bottom of the page. For more information, see: Change the page orientation Cause: The photo image had light blue, gray, or brown hues that print near the bottom of the page. Printouts have horizontal streaks or lines Try the following solutions if your printout has lines, streaks, or marks on it that run sideto-side across the width of the page. • Solution 1: Make sure the paper is loaded correctly • Solution 2: Check the print quality setting • Solution 3: If the print cartridge was dropped, wait for it to recover • Solution 4: Clean the print cartridge nozzles • Solution 5: Clean the print cartridges Solution 1: Make sure the paper is loaded correctly Solution: Make sure the paper is loaded correctly. For more information, see: Load full-size paper Cause: The paper was not feeding properly or was not loaded correctly. If this did not solve the issue, try the next solution. Print quality troubleshooting 107