HP Integrity rx1620 Installation Guide, Second Edition - HP Integrity rx1620 - Page 26

Installing Processors and Memory, Closing the Cover

Get HP Integrity rx1620 PDF manuals and user guides View all HP Integrity rx1620 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

Installing and Configuring Installing Processors and Memory Step 2. Close the cover by moving the latch handle clockwise. Figure 3-11 Closing the Cover OPEN CLOSED Installing Processors and Memory This section provides information about installing processors and memory. The processors and memory slots are located on the system board, which is accessible by removing the system cover. WARNING Voltages are present at various locations within the server whenever an AC power source is connected. This voltage is present even when the main power switch is in the off position. Ensure that the system is powered-down and all power sources have been disconnected from the server prior to attempting the following procedures. Failure to observe this warning could result in personal injury or damage to equipment. CAUTION Do not operate the server without the cover in place. Operation of the server without the cover in place may result in server failure. Operation of the server without the cover in place will make the server susceptible to EMI problems. Front of Chassis 26 Chapter 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
Chapter 3
Installing and Configuring
Installing Processors and Memory
26
Step 2.
Close the cover by moving the latch handle clockwise.
Figure 3-11 Closing the Cover
Installing Processors and Memory
This section provides information about installing processors and memory. The processors and memory slots
are located on the system board, which is accessible by removing the system cover.
WARNING
Voltages are present at various locations within the server whenever an AC power
source is connected. This voltage is present even when the main power switch is in
the off position.
Ensure that the system is powered-down and all power sources have been
disconnected from the server prior to attempting the following procedures.
Failure to observe this warning could result in personal injury or damage to
equipment.
CAUTION
Do not operate the server without the cover in place. Operation of the server without the cover
in place may result in server failure. Operation of the server without the cover in place will
make the server susceptible to EMI problems.
CLOSED
OPEN
Front of Chassis