HP Integrity rx1620 Installation Guide, Second Edition - HP Integrity rx1620 - Page 43

Removing the MP Card Blank

Get HP Integrity rx1620 PDF manuals and user guides View all HP Integrity rx1620 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 43 highlights

Installing and Configuring Optional Management Processor Card (MP) Step 4. Remove the blank retaining tab out of its socket on the system chassis and remove the blank from the system. Figure 3-28 Removing the MP Card Blank Step 5. Remove the insulator between the battery and the battery socket on the management processor card. Step 6. Align the MP card over the two mounting posts on the system board and align the three connectors of the MP card with the cutouts on the rear panel. Step 7. Carefully push the 10/100 Management LAN, 15-pin VGA and 25-pin serial connectors through their openings on the rear panel. CAUTION Special care should be used when mating the connectors of the MP card with the sheet metal of the rear panel. It is possible to damage the EMI gasket of the RJ-45 of the card. Step 8. Connect the MP card cable to its connector on the system board. Chapter 3 43

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
Chapter 3
Installing and Configuring
Optional Management Processor Card (MP)
43
Step 4.
Remove the blank retaining tab out of its socket on the system chassis and remove the blank from
the system.
Figure 3-28 Removing the MP Card Blank
Step 5.
Remove the insulator between the battery and the battery socket on the management processor
card.
Step 6.
Align the MP card over the two mounting posts on the system board and align the three connectors
of the MP card with the cutouts on the rear panel.
Step 7.
Carefully push the 10/100 Management LAN, 15-pin VGA and 25-pin serial connectors through
their openings on the rear panel.
CAUTION
Special care should be used when mating the connectors of the MP card with the
sheet metal of the rear panel. It is possible to damage the EMI gasket of the RJ-45 of
the card.
Step 8.
Connect the MP card cable to its connector on the system board.