HP Mini 5102 HP Mini 5102 - Maintenance and Service Guide - Page 74
Remove the 2 Phillips PM2.5×5.0 screws
View all HP Mini 5102 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Remove the display assembly: 1. Disconnect the following cables and grounding tape from the system board and cable routing clips: (1) Display panel cable (2) Display panel cable grounding tape (3) WLAN cables (4) WWAN cables (select models only) (5) Microphone cable CAUTION: Support the display assembly when removing the following screws. Failure to support the display assembly can result in damage to the display assembly and other device components. 2. Remove the 2 Phillips PM2.5×5.0 screws (1) that secure the display assembly to the device. 3. Remove the display assembly (2). 66 Chapter 4 Removal and replacement procedures
Remove the display assembly:
1.
Disconnect the following cables and grounding tape from the system board and cable routing clips:
(1)
Display panel cable
(2)
Display panel cable grounding tape
(3)
WLAN cables
(4)
WWAN cables (select models only)
(5)
Microphone cable
CAUTION:
Support the display assembly when removing the following screws. Failure to support
the display assembly can result in damage to the display assembly and other device components.
2.
Remove the 2 Phillips PM2.5×5.0 screws
(1)
that secure the display assembly to the device.
3.
Remove the display assembly
(2)
.
66
Chapter 4
Removal and replacement procedures