HP Pavilion 11-h110nr HP Pavilion 11 x2 PC Maintenance and Service Guide - Page 43

from the heat sink. The wireless antenna, Remove the wireless antenna

Get HP Pavilion 11-h110nr PDF manuals and user guides View all HP Pavilion 11-h110nr manuals
Add to My Manuals
Save this manual to your list of manuals

Page 43 highlights

Remove the wireless antenna: 1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module. NOTE: The WLAN antenna cable labeled "1" connects to the WLAN module "Main" terminal labeled "1". The WLAN antenna cable labeled "2" connects to the WLAN module "Aux" terminal labeled "2". 2. Release the wireless antenna cables from the routing clips (2) built into the display panel assembly. 3. Detach the wireless antenna transceivers (3) from the heat sink. (The wireless antenna transceiver is attached to the heat sink with double-sided tape.) 4. Remove the wireless antenna cables and transceivers. Reverse this procedure to install the wireless antenna cables and transceivers. Tablet component replacement procedures 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
Remove the wireless antenna:
1.
Disconnect the WLAN antenna cables
(1)
from the terminals on the WLAN module.
NOTE:
The WLAN antenna cable labeled “1” connects to the WLAN module “Main” terminal
labeled “1”. The WLAN antenna cable labeled “2” connects to the WLAN module “Aux” terminal
labeled “2”.
2.
Release the wireless antenna cables from the routing clips
(2)
built into the display
panel assembly.
3.
Detach the wireless antenna transceivers
(3)
from the heat sink. (The wireless antenna
transceiver is attached to the heat sink with double-sided tape.)
4.
Remove the wireless antenna cables and transceivers.
Reverse this procedure to install the wireless antenna cables and transceivers.
Tablet component replacement procedures
35