HP Pavilion All-in-One MS210 Maintenance and Service Guide: HP Pro All-in-One - Page 28

Fan, Remove the stand see

Get HP Pavilion All-in-One MS210 - Desktop PC PDF manuals and user guides View all HP Pavilion All-in-One MS210 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

5. Remove the back cover (see Back cover on page 18). 6. Remove the system board shield (see System board shield on page 19). 7. Remove the antenna cables (1) from the module. 8. Remove the screw (2) that secures the module to the system board. NOTE: Some modules may be secured by two screws. 9. Lift the module out of the slot at an angle. NOTE: The WLAN module has a notch to prevent incorrect installation. To install the WLAN module, reverse the removal procedures. Fan 1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 5). 2. Remove the stand (see Stand on page 11). 3. Remove the hard drive (see Hard drive on page 13). 4. Remove the optical drive (see Optical drive on page 16). 5. Remove the back cover (see Back cover on page 18). 6. Remove the system board shield (see System board shield on page 19). 7. Remove the four screws (1) that secure the fan to the system board, and then lift the fan partially out of the computer. 22 Chapter 3 Removal and Replacement Procedures

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
5.
Remove the back cover (see
Back cover
on page
18
).
6.
Remove the system board shield (see
System board shield
on page
19
).
7.
Remove the antenna cables
(1)
from the module.
8.
Remove the screw
(2)
that secures the module to the system board.
NOTE:
Some modules may be secured by two screws.
9.
Lift the module out of the slot at an angle.
NOTE:
The WLAN module has a notch to prevent incorrect installation.
To install the WLAN module, reverse the removal procedures.
Fan
1.
Prepare the computer for disassembly (see
Preparing to disassemble the computer
on page
5
).
2.
Remove the stand (see
Stand
on page
11
).
3.
Remove the hard drive (see
Hard drive
on page
13
).
4.
Remove the optical drive (see
Optical drive
on page
16
).
5.
Remove the back cover (see
Back cover
on page
18
).
6.
Remove the system board shield (see
System board shield
on page
19
).
7.
Remove the four screws
(1)
that secure the fan to the system board, and then lift the fan partially
out of the computer.
22
Chapter 3
Removal and Replacement Procedures