HP Pavilion zt1100 HP Pavilion Notebook zt1000, xz100 and Omnibook xt1000 Seri - Page 49

Removing the System SDRAM Module

Get HP Pavilion zt1100 - Notebook PC PDF manuals and user guides View all HP Pavilion zt1100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 49 highlights

Reassembly Notes • Carefully press the SDRAM module into the connector at an angle of about 30°, until it is fully inserted. Then press down on both sides of the module until the latches snap closed. Figure 18. Installing an Expansion SDRAM Module Removing the System SDRAM Module Removal Procedure 1. Unplug the AC adapter, if present, and remove the battery. 2. Remove the keyboard cover (page 44). 3. Open the keyboard (page 48, steps 1 though 5). You don't need to disconnect the keyboard cable. 4. Press outward to release the latches at the sides of the SDRAM module (so that the free edge of the module pops up), then pull the module out of the connector. Figure 19. Removing the System SDRAM Module Reassembly Notes • Carefully press the SDRAM module into the connector at an angle of about 30°, until it is fully inserted. Then press down on both sides of the module until the latches snap closed. zt1100/xz100 and xt1000 Series Troubleshooting and Self-Repair Guide Removing and Replacing Parts 49

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
zt1100/xz100 and xt1000 Series
Removing and Replacing Parts
49
Troubleshooting and Self-Repair Guide
Reassembly Notes
•
Carefully press the SDRAM module into the connector at an angle of about 30
°
, until it is fully
inserted. Then press down on both sides of the module until the latches snap closed.
Figure 18. Installing an Expansion SDRAM Module
Removing the System SDRAM Module
Removal Procedure
1. Unplug the AC adapter, if present, and remove the battery.
2. Remove the keyboard cover (page 44).
3. Open the keyboard (page 48, steps 1 though 5). You don
’
t need to disconnect the keyboard cable.
4. Press outward to release the latches at the sides of the SDRAM module (so that the free edge of
the module pops up), then pull the module out of the connector.
Figure 19. Removing the System SDRAM Module
Reassembly Notes
•
Carefully press the SDRAM module into the connector at an angle of about 30
°
, until it is fully
inserted. Then press down on both sides of the module until the latches snap closed.