HP RP7 Maintenance & Service Guide HP RP7 Retail System Model 7800 - Page 80
mounting bracket
View all HP RP7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
10. Slide the back plate mounting bracket into the mounting hole on the rear of the RP7 base (1), and install the two screws included with the customer display into the screw holes on top of the mounting bracket (2). 11. Replace the power supply cover by lowering it down over the neck of the base then sliding it back until it snaps in place. 70 Chapter 8 Removal and Replacement Procedures
10.
Slide the back plate mounting bracket into the mounting hole on the rear of the RP7 base
(1)
,
and install the two screws included with the customer display into the screw holes on top of the
mounting bracket
(2)
.
11.
Replace the power supply cover by lowering it down over the neck of the base then sliding it
back until it snaps in place.
70
Chapter 8
Removal and Replacement Procedures