HP StorageWorks 1606 HP StorageWorks Fabric OS 6.3.0 release notes (5697-0358, - Page 55

Director or DC04 SAN Director

Page 55 highlights

Blades are not shown in when a slot is hot plugged in to a DC SAN Fixed in Fabric OS 6.3.0 Director or DC04 SAN Director. With VF, deleting a FID while in the FID leads to undesirable conditions. The user is stuck in the FID and all commands run generate an error Fixed in Fabric OS 6.3.0 message. FOS still reports some FRU failures as link incidents on port 0xFF. Fixed in Fabric OS 6.3.0 After FCoE login, FOS v6.1.2_cee does not filter packets with SRCMAC=FCF-MAC. Fixed in Fabric OS 6.3.0 Reboot of all 4 nodes in an Encryption Group (EG) with multiple rekeys Fixed in Fabric OS 6.3.0 pending resulted in new rekey sessions being unable to start. IPFC address is shown instead of chasis IP address in SNMP Trap for Fixed in Fabric OS 6.3.0 DC04 SAN Director. Required detailed error description while the port enable/disable fails. Fixed in Fabric OS 6.3.0 Man page/online help on "fcoelogingroup --create xxx" should replace Fixed in Fabric OS 6.3.0 allow-all by "allowall." Pathinfo command failure occurs when run on FOS 6.1, if the path traverses through FOS 6.2.x. Fixed in Fabric OS 6.3.0 2408 FCoE CN Switch should be able to set enable password. Fixed in Fabric OS 6.3.0 When Quality of Service (QoS) is enabled by default / not utilized, performance of the SAN drops. Disable QoS by default on 4Gb platforms, 8Gb long-distance and make portcfg values such as fill words, trunk information persistent across upgrade/downgrades. Fixed in Fabric OS 6.3.0 Detected termination of 0.weblinker.fcg:1315. Fixed in Fabric OS 6.3.0 LUN state became disabled with reason "Key not in sync" after 12 hour run of stress test KV link failure/restore with online rekey. Fixed in Fabric OS 6.3.0 Devices attached to AG are not considered as Virtual. Fixed in Fabric OS 6.3.0 Persistently disabled GE port on a Multiprotocol router blade becomes Fixed in Fabric OS 6.3.0 disabled after hafailover. rcsd terminated on 8/80 SAN Switch during a configDownload on all switches in the fabric. Fixed in Fabric OS 6.3.0 Key id sate shows "key expired: Allowing data append" while key lifespan = 0 minute. Fixed in Fabric OS 6.3.0 Rekey operation is restarted but hung after all the Encryption Engines Fixed in Fabric OS 6.3.0 (EEs) in the encryption group are rebooted. LUN state shows target offline after disconnect/reconnected both initi- Fixed in Fabric OS 6.3.0 ator and target. Containers for 4/32B SAN Switch not ready for discover LUN. Fixed in Fabric OS 6.3.0 FOS 6.2 Radius Calling-station-ID (31) implementation is used for both Fixed in Fabric OS 6.3.0 "device called by" and "workstation called from" hostname/IP address. HP StorageWorks Fabric OS 6.3.0 release notes 55

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70

Fixed in Fabric OS 6.3.0
Blades are not shown in when a slot is hot plugged in to a DC SAN
Director or DC04 SAN Director.
Fixed in Fabric OS 6.3.0
With VF, deleting a FID while in the FID leads to undesirable conditions.
The user is stuck in the FID and all commands run generate an error
message.
Fixed in Fabric OS 6.3.0
FOS still reports some FRU failures as link incidents on port 0xFF.
Fixed in Fabric OS 6.3.0
After FCoE login, FOS v6.1.2_cee does not filter packets with SRC-
MAC=FCF-MAC.
Fixed in Fabric OS 6.3.0
Reboot of all 4 nodes in an Encryption Group (EG) with multiple rekeys
pending resulted in new rekey sessions being unable to start.
Fixed in Fabric OS 6.3.0
IPFC address is shown instead of chasis IP address in SNMP Trap for
DC04 SAN Director.
Fixed in Fabric OS 6.3.0
Required detailed error description while the port enable/disable fails.
Fixed in Fabric OS 6.3.0
Man page/online help on "fcoelogingroup --create xxx" should replace
allow-all by "allowall."
Fixed in Fabric OS 6.3.0
Pathinfo command failure occurs when run on FOS 6.1, if the path
traverses through FOS 6.2.x.
Fixed in Fabric OS 6.3.0
2408 FCoE CN Switch should be able to set enable password.
Fixed in Fabric OS 6.3.0
When Quality of Service (QoS) is enabled by default / not utilized,
performance of the SAN drops. Disable QoS by default on 4Gb plat-
forms, 8Gb long-distance and make portcfg values such as fill words,
trunk information persistent across upgrade/downgrades.
Fixed in Fabric OS 6.3.0
Detected termination of 0.weblinker.fcg:1315.
Fixed in Fabric OS 6.3.0
LUN state became disabled with reason "Key not in sync" after 12
hour run of stress test KV link failure/restore with online rekey.
Fixed in Fabric OS 6.3.0
Devices attached to AG are not considered as Virtual.
Fixed in Fabric OS 6.3.0
Persistently disabled GE port on a Multiprotocol router blade becomes
disabled after hafailover.
Fixed in Fabric OS 6.3.0
rcsd terminated on 8/80 SAN Switch during a configDownload on
all switches in the fabric.
Fixed in Fabric OS 6.3.0
Key id sate shows "key expired: Allowing data append" while key
lifespan = 0 minute.
Fixed in Fabric OS 6.3.0
Rekey operation is restarted but hung after all the Encryption Engines
(EEs) in the encryption group are rebooted.
Fixed in Fabric OS 6.3.0
LUN state shows target offline after disconnect/reconnected both initi-
ator and target.
Fixed in Fabric OS 6.3.0
Containers for 4/32B SAN Switch not ready for discover LUN.
Fixed in Fabric OS 6.3.0
FOS 6.2 Radius Calling-station-ID (31) implementation is used for both
"device called by" and "workstation called from" hostname/IP address.
HP StorageWorks Fabric OS 6.3.0 release notes
55