Husqvarna 562 XP G Workshop Manual - Page 21

6.7 Assembling the start/stop control 1 Fit the new stop control (A) and tighten screw (B) in place at a torque of 1 Nm. Slide in the stop control in the rubber sleeve C and hook the sleeve on the guide taps. See figure 15. Safety equipment Fig 15 2 Attach the cables as outlined in figure 16. 3 Attach the air filter holder. See the "Assembling the carburettor" chapter. 4 Fit air filter and cylinder cover. 6.8 Resistance test - stop function Dismantle the ignition module as outlined in "7.7 Dismantling the ignition module and flywheel". Cut open the shrink tube covering both cables and shrink tubing that encloses the cable ends. Clean the contact areas and check resistance in the following way: Test the resistance by connecting a multimeter to the cable ends. NOTE! The power switch must be in the "on" position to get the correct reading. See figure 17. The stop switch is in the "on" position when the button is held down (see figure 17) and in the "off" position when the button is in neutral. Resistance can be 0.5 Ohm at most with the power switch in the "on" position. When assembling (see figure 18), pull the cable ends apart and slide on a thicker shrink tube over both cables. Then slide on the thinner shrink tubes over each cable. Connect the cable ends together. Slide the thinner shrink tubes over the cable ends and heat the shrink tube first on both cables separately. Slide the thicker shrink tube over the thinner shrink tubes and then heat the thicker shrink tube. Fig 16 Fig 17 Fig 18 English - 21