Husqvarna 562 XP G Workshop Manual - Page 33

3 Dismantle the air filter, the filter holder, the cable from the intake flange holder and the carburettor and the throttle cable as outlined in "Dismantling the carburettor". NOTE! The lug on the carburettor sits on the bracket on the partition wall. Fig 24 4 Hook off the cabling from the holder on the intake system (J). Knock out the POP-out window using a screwdriver. See figure 25. Lower the tank slightly and slide the fuel hose down into the hole. Loosen the lower screws of the intake system using the POP-out hole and the fuel hose hole. Loosen the other screws. Fig 25a 5 Dismantle the intake system. Pull up and then outward. See figure 26. Cleaning and inspection Clean and check all parts carefully. Parts must be replaced if cracked or showing signs of other defects. Always use original spare parts. 7.13 Assembling the intake system 1 Assemble the intake system. 2 Fit the lower screws of the intake system using the POP-out hole and the fuel hose hole. Fit the other screws. Fit the fuel hose and the throttle cable to their attachments. See figure 24. Fit the rubber grommet to the throttle cable. Push the tank back in position. Hook on the cabling to the holder on the intake system. 3 NOTE! Press the lug on the carburettor in place on its bracket on the partition wall. See figure 24. Fit the carburettor, the filter holder and the air filter as outlined in "Assembling the carburettor". Fig 25b Fig 26 Repair Instructions English - 33